Hose and Pipe: Installation
CAUTION:
- If the hose and pipe has been replaced, add an appropriate amount of compressor oil to the compressor. Refer to ADJUSTMENT .
- Do not start the engine before charging refrigerant.
- If the engine is started with no refrigerant charge, replace the compressor.
- Replace the O-rings with new parts, and then apply compressor oil.
- When connecting hoses, do not apply an excessive force to them. After installing, check that no torsion or excessive tension applied to the hoses.
- Install each part in the reverse order of removal.
- Charge refrigerant. Refer to
PROCEDURE .
Tightening torque:
Refer to AIR CONDITIONING UNIT .