LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Automatic Transaxle) >> Transmission Mounting System >> Removal >> Transmission Rear CROSSMEMBER & Rear Cushion Rubber

Transmission Rear CROSSMEMBER & Rear Cushion Rubber

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground cable from battery.
  2. Lift up the vehicle.
  3. Remove the under cover. Refer to REMOVAL .
  4. Remove the front exhaust pipe. Refer to REMOVAL .
  5. Remove the heat shield cover.
    Fig 1: Identifying Heat Shield Cover
    G05019661Courtesy of SUBARU OF AMERICA, INC.
  6. Set the transmission jack under transmission. Make sure that the support plate of transmission jack does not touch the oil pan.
  7. Remove the transmission rear crossmember.
    Fig 2: Locating Rear Crossmember Bolts
    G06651991Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the rear cushion rubber.
scientia non olet · About LEMON Manuals