LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (HVAC System (Auto Ac) (Diagnostics)) >> Diagnostic Procedure for Sensors >> In-Vehicle Sensor >> Wiring Diagram

In-Vehicle Sensor: Wiring Diagram

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Air Conditioning System < Refer to appropriate SYSTEM WIRING DIAGRAM.>

Fig 1: In-Vehicle Sensor - Wiring Diagram (Failure Related To In-Vehicle Sensor Is Indicated In Self-Diagnosis)
G05663225Courtesy of SUBARU OF AMERICA, INC.
Step Check Yes No
1 CHECK IN-VEHICLE SENSOR. 
Perform the inspection of in-vehicle sensor unit. < Refer to INSPECTION , In-Vehicle Sensor (Auto A/C Model). >		 Is the in-vehicle sensor normal? Go to step 2  . Replace the in-vehicle sensor. < Refer to REMOVAL , In-Vehicle Sensor (Auto A/C Model). >
2 CHECK INPUT SIGNAL FOR IN-VEHICLE SENSOR. 
  1. Turn the ignition switch to ON.
  2. Measure the voltage between in-vehicle sensor harness connector terminals.

    Connector & terminal 

    (i55) No. 2 (+) - No. 1 (-): 

 Is the voltage approx. 5 V? Go to step 6  . Go to step 3  .
3 CHECK AUTO A/C CONTROL MODULE OUTPUT SIGNAL. 
  1. Turn the ignition switch to OFF.
  2. Remove the auto A/C control module.
  3. Turn the ignition switch to ON.
  4. Measure the voltage between connector terminals of auto A/C control module.

    Connector & terminal 

    (i88) No. 17 (+) - (i88) No. 14 (-): 

 Is the voltage approx. 5 V? Go to step 4  . Go to step 6  .
4 CHECK HARNESS BETWEEN AUTO A/C CONTROL MODULE AND IN-VEHICLE SENSOR. 
  1. Turn the ignition switch to OFF.
  2. Disconnect the connector from the auto A/C control module.
  3. Measure the resistance of harness between auto A/C control module and in-vehicle sensor.

    Connector & terminal 

    (i55) No. 2 - (i88) No. 17: 

 Is the resistance less than 1 Ω? Go to step 5  . Repair the harness between auto A/C control module and in-vehicle sensor.
5 CHECK HARNESS BETWEEN AUTO A/C CONTROL MODULE AND IN-VEHICLE SENSOR. 
Measure the resistance of harness between auto A/C control module and in-vehicle sensor.
Connector & terminal 
(i55) No. 1 - (i88) No. 14: 		 Is the resistance less than 1 Ω? Go to step 6  . Repair the harness between auto A/C control module and in-vehicle sensor.
6 CHECK FOR POOR CONTACT. 
Check poor contact of auto A/C control module connector.		 Is there poor contact of connector? Repair the connector. Replace the auto A/C control module. < Refer to REMOVAL , Control Unit (Auto A/C Model). >
scientia non olet · About LEMON Manuals