Center Exhaust Pipe: Removal
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.
- Remove the collector cover.
- Disconnect the ground cable from battery.
- Remove the intercooler. < Refer to REMOVAL , Intercooler. >
- Lift up the vehicle.
- Remove the bolts which secure the lower side of the turbocharger lower cover.
- Lower the vehicle.
- Remove the turbocharger upper cover.
- Remove the bolts which hold the upper side of the turbocharger lower cover.
- Remove the upper side bolts and nuts that hold the center exhaust pipe on the turbocharger, and remove the turbocharger cover stay (A).
- Lift up the vehicle.
- Remove the lower side nuts (two places) that hold the center exhaust pipe on the turbocharger.
- Disconnect the connector from the rear oxygen sensor, and remove the clip (A) holding the rear oxygen sensor harness.
- Remove the rear exhaust pipe from center exhaust pipe.
- Remove the bolt which holds center exhaust pipe to transmission.
- Remove the bolt which holds center exhaust pipe to hanger bracket, and remove the center exhaust pipe.CAUTION: Be careful not to drop the center exhaust pipe.
- Remove the turbocharger lower cover.