CROSSMEMBER And Cushion Rubber

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Install the transmission cushion rubber to the transmission, and tighten the bolt (A).
Install the transmission cushion rubber to the center crossmember, and tighten the nut (B).
Tightening torque:

Bolt (A)

35 N.m (3.6 kgf-m, 25.8 ft-lb)

Nut (B)

35 N.m (3.6 kgf-m, 25.8 ft-lb)

Fig 1: Identifying Transmission Cushion Rubber Nut And Bolt
Courtesy of SUBARU OF AMERICA, INC.
Install the front crossmember and rear crossmember.
Tightening torque:

T1: 70 N.m (7.1 kgf-m, 51.6 ft-lb)

T2: 140 N.m (14.3 kgf-m, 103.3 ft-lb)

Fig 2: Front Crossmember And Rear Crossmember Bolts With Torque Specifications
Courtesy of SUBARU OF AMERICA, INC.
Remove the transmission jack.
Install the heat shield cover. < Refer to INSTALLATION , Heat Shield Cover. >
Install the front and center exhaust pipe. < Refer to INSTALLATION , Front Exhaust Pipe. > < Refer to INSTALLATION , Center Exhaust Pipe. >
Install the rear exhaust pipe and muffler. < Refer to INSTALLATION , Rear Exhaust Pipe. > < Refer to INSTALLATION , Muffler. >
Lower the vehicle.
Connect the battery ground terminal.