Reverse Idler Gear: Installation
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
- Install the reverse shifter lever, washer, reverse idler gear, washer and reverse idler gear shaft, and secure them with the straight pin.
- Check and adjust clearance between the reverse idler gear and the timing case wall surface. < Refer to INSTALLATION , Reverse Idler Gear. > < Refer to ADJUSTMENT , Reverse Idler Gear. >
- Install the shifter forks and rods. < Refer to INSTALLATION , Shifter Fork and Rod. >
- Install the front differential assembly. < Refer to INSTALLATION , Front Differential Assembly. >
- Install the main shaft assembly for single-range. < Refer to INSTALLATION , Main Shaft Assembly for Single-Range. >
- Install the drive pinion shaft assembly. < Refer to INSTALLATION , Drive Pinion Shaft Assembly. >
- Install the transmission case. < Refer to INSTALLATION , Transmission Case. >
- Install the transfer case together with the extension case assembly. < Refer to INSTALLATION , Transfer Case and Extension Case Assembly. >
- Install the back-up light switch and the neutral position switch. < Refer to INSTALLATION , Switches and Harness. >
- Install the manual transmission assembly to the vehicle. < Refer to INSTALLATION , Manual Transmission Assembly. >