LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Manual Transaxle & Differential) >> Main Shaft Assembly for Single-Range >> Installation

Main Shaft Assembly for Single-Range: Installation

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the needle bearing and oil seal to the front of the transmission single-range main shaft assembly.
    NOTE:
    • Wrap the clutch splined section with vinyl tape to prevent damage to the oil seal.
    • Apply NICHIMOLY N-130 (or equivalent) to the sealing lip of the oil seal.
    • Use a new oil seal.
  2. Align the transmission case knock pin into the knock pin hole of the needle bearing outer race.
    NOTE: Align the end face of the seal with surface (A) when installing the oil seal.
    Fig 1: Aligning End Face Of Seal With Surface
    G05003053Courtesy of SUBARU OF AMERICA, INC.
  3. Install the drive pinion shaft assembly. < Refer to INSTALLATION , Drive Pinion Shaft Assembly. >
  4. Install the transmission case. < Refer to INSTALLATION , Transmission Case. >
  5. Install the transfer case together with the extension case assembly. < Refer to INSTALLATION , Transfer Case and Extension Case Assembly. >
  6. Install the manual transmission assembly to the vehicle. < Refer to INSTALLATION , Manual Transmission Assembly. >
scientia non olet · About LEMON Manuals