Rear Door: Removal
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the ground cable from battery.
- Remove the rear door trim.< Refer to REAR DOOR , REMOVAL, Door Trim. >
- Remove the rear speaker.< Refer to REMOVAL , Rear Speaker. >
- Remove the sealing cover.< Refer to REMOVAL , Rear Sealing Cover. >
- Remove the door sash and rear door glass.< Refer to REMOVAL , Rear Door Glass. >
- Remove the rear door regulator and motor assembly.< Refer to REMOVAL , Rear Regulator and Motor Assembly. >
- Remove the rear door latch.< Refer to REMOVAL , Rear Door Latch and Door Lock Actuator Assembly. >
- Remove the rear outer handle.< Refer to REMOVAL , Rear Outer Handle. >
- Remove the rear door weather strip.NOTE: If the weather strip clip is removed with excessive force, the weather strip may be damaged. Be sure to use clip remover to remove.
- Remove the bolts and nuts to remove the door checker.
- Pull the door harness connector inside the center pillar, then disconnect the connector.
- Put a wooden block on jack and place jack under the rear door. Support the rear door with a jack to protect it from damage.
- Remove the door-side bolts for upper and lower hinges to remove the rear door panel.
- Remove the door hinge from vehicle.