LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Anti-Theft System - Security And Locks) >> Rear Door Latch and Door Lock Actuator Assembly >> Removal

Rear Door Latch and Door Lock Actuator Assembly: Removal

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from battery.
  2. Remove the rear door trim. < Refer to REAR DOOR , REMOVAL, Door Trim. >
  3. Remove the wire from the rear inner remote. < Refer to REMOVAL , Rear Inner Remote. >
  4. Remove the sealing cover. < Refer to REMOVAL , Rear Sealing Cover. >
  5. Remove the rear door glass. < Refer to REMOVAL , Rear Door Glass. >
  6. Disconnect the harness connector of rear door latch and door lock actuator assembly.
  7. Remove the screws, and remove the rear door latch & door lock actuator assembly.
    Fig 1: Locating Rear Door Latch And Door Lock Actuator Assembly Mounting Screws
    G05663687Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals