LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Seat System - Seats) >> Front Seat >> Disassembly >> Passenger's Seat

Passenger's Seat

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • If the seat cushion cover is removed or replaced, make sure to perform passenger detection system adjustment after installing the seat to the vehicle. < Refer to OPERATION , System Calibration (Rezeroing). >

    Failure to do so may prevent the passenger's airbag from operating properly.

  • The passenger detection system (passenger seat only) control unit, passenger detection sensor, seat cushion pad and seat cushion frame are considered as a single seat cushion pad and frame assembly. Never remove the passenger detection control unit or the pressure sensor from the seat cushion frame.
  • If the seat cushion cover is removed, make sure to replace the hang wire on the seat cushion side with a new wire.
  1. Remove the seat from the vehicle. < Refer to PASSENGER'S SEAT , REMOVAL, Front Seat. >
  2. Refer to the disassembly procedures for the driver's seat. < Refer to DRIVER'S SEAT (NORMAL) , DISASSEMBLY, Front Seat. >
scientia non olet · About LEMON Manuals