LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Seat System - Seats) >> Front Seat >> Removal >> Passenger's Seat

Passenger's Seat

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Always refer to "CAUTION" of "General Description" before starting the work. < Refer to CAUTION , General Description. >
  1. Disconnect the ground cable from battery, and wait for 60 seconds or more before starting work.
  2. Remove the headrest.
  3. Remove the slide rail installing bolt.
    1. Tilt the backrest forward and move the seat to the front most position.
    2. Remove the rear bolt cover at the rear side of the slide rail and remove the bolt.
    3. Move the seat to the rearmost position, and remove the bolt on the front side of the slide rail.
  4. Disconnect all the connectors of connector holder in the backside of seat cushion.
    • Harness connector of occupant detection control module
    • Side airbag connector
    • Seat heater connector (model with seat heater)
  5. Remove the seat from vehicle.
scientia non olet · About LEMON Manuals