Heater and Cooling Unit: Installation

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Replace the O-rings on hoses and pipes with new parts, and then apply compressor oil.

Install each part in the reverse order of removal.
Fill engine coolant.
- Non-turbo model: < Refer to FILLING OF ENGINE COOLANT , REPLACEMENT, Engine Coolant. >
- Turbo model: < Refer to FILLING OF ENGINE COOLANT , REPLACEMENT, Engine Coolant. >
Charge refrigerant. < Refer to PROCEDURE , Refrigerant Charging Procedure. >
Tightening torque:

Refer to "COMPONENT" of "General Description".

Heater cooling unit: < Refer to HEATER COOLING UNIT , COMPONENT, General Description. >

Blower motor unit: < Refer to BLOWER MOTOR UNIT , COMPONENT, General Description. >