Section 23 (HVAC System (Heater, Ventilator And A/C)): Evaporator: Installation
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- If the evaporator has been replaced, add an appropriate amount of compressor oil to the evaporator. < Refer to ADJUSTMENT , Compressor Oil. >
- Replace the O-rings on hoses and pipes with new parts, and then apply compressor oil.
- Make sure that the water seal packing on the cover attachment area is securely attached.
- Install the sensor in the location shown in the figures below.
- Install each part in the reverse order of removal.
- Charge refrigerant. < Refer to
PROCEDURE , Refrigerant Charging Procedure. >
Tightening torque:
Refer to "COMPONENT" of "General Description".
Heater cooling unit: < Refer to HEATER COOLING UNIT , COMPONENT, General Description. >
Blower motor unit: < Refer to BLOWER MOTOR UNIT , COMPONENT, General Description. >