LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical (H4DO) >> Cam Carrier >> Removal >> Cam Carrier RH

Cam Carrier RH

  1. Remove the engine from the vehicle. Refer to REMOVAL .
  2. Remove the chain cover. Refer to REMOVAL .
  3. Remove the timing chain RH. Refer to TIMING CHAIN RH .
  4. Remove the cam sprocket RH. Refer to CAM SPROCKET RH .
    NOTE: This procedure is required only when disassembling the cam carrier RH.
  5. Remove the rocker cover RH. Refer to ROCKER COVER RH .
  6. Remove the clip holding the engine harness from cam carrier RH.
    Fig 1: Locating Engine Harness Holding Clip
    G08317006Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the fuel pipe RH and the fuel injector RH.
    1. Disconnect the connector from fuel injector RH.
      Fig 2: Locating Fuel Injector RH Connectors
      G08317008Courtesy of SUBARU OF AMERICA, INC.
    2. Disconnect the quick connector from fuel pipe RH.
      NOTE: Disconnect the quick connector as shown in the figure.
      Fig 3: Disconnecting Fuel Pipe RH Quick Connector
      G08580172Courtesy of SUBARU OF AMERICA, INC.
      Fig 4: Locating Quick Connector
      G08317010Courtesy of SUBARU OF AMERICA, INC.
    3. Remove the bolts securing the fuel pipe RH, and remove the fuel pipe RH and the fuel injector RH.
      Fig 5: Locating Tightening Sequence Of Fuel Pipe RH Mounting Bolts
      G08317011Courtesy of SUBARU OF AMERICA, INC.
  8. Insert the steel rods into ST, and set the engine so that the camshaft RH is facing up.
    CAUTION:
    • If the engine is standing on one side without inserting the steel rod into ST, engine may lose balance and fall down. Be sure to insert the steel rod into ST to extend the length.
    • Use the steel rod with enough strength.
    • Be careful not to pinch the engine harness with ST.

    ST 499817100 ENGINE STAND

    Fig 6: Supporting Engine Using Engine Stand
    G08563037Courtesy of SUBARU OF AMERICA, INC.
  9. Loosen the bolts holding the cam carrier RH equally, a little at a time in numerical sequence as shown in the figure and remove the cam carrier RH.
    Fig 7: Identifying Loosening Sequence Of Cam Carrier RH Mounting Bolts
    G08563038Courtesy of SUBARU OF AMERICA, INC.
  10. Remove the O-ring and the roller rocker arm from cylinder head RH.
    NOTE: Be careful not to confuse the roller rocker arms.
    Fig 8: Locating Cylinder Head RH O-Ring And Roller Rocker Arms
    G08317014Courtesy of SUBARU OF AMERICA, INC.
  11. Remove the valve shim and the roller rocker arm pivot from cylinder head RH.
    NOTE: Be careful not to confuse the valve shim and the roller rocker arm pivot.
    Fig 9: Locating Cylinder Head RH Valve Shims And Roller Arm Pivots
    G08317015Courtesy of SUBARU OF AMERICA, INC.
  12. Remove the liquid gasket from cam carrier RH and cylinder head RH.
scientia non olet · About LEMON Manuals