LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical (H4DO) >> Cam Sprocket >> Removal >> Cam Sprocket RH

Cam Sprocket RH

NOTE: When replacing a single part, perform the work with the engine assembly installed to body.
  1. Remove the chain cover. Refer to REMOVAL .
  2. Remove the timing chain RH. Refer to TIMING CHAIN RH .
  3. Hold the intake cam sprocket RH using the ST1 and ST2, and remove the bolts using the ST3.

    ST1 18355AA000 PULLEY WRENCH

    ST2 18334AA030 PULLEY WRENCH PIN SET

    ST3 18270KA010 SOCKET

    Fig 1: Removing Intake Cam Sprocket RH Mounting Bolt Using Tools
    G08562996Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the intake cam sprocket RH.
  1. Remove the chain cover. Refer to REMOVAL .
  2. Remove the timing chain RH. Refer to TIMING CHAIN RH .
  3. Hold the exhaust cam sprocket RH by inserting the 6 mm (0.236 in) dia. steel rod into the exhaust cam sprocket RH hole as shown in the figure, and remove the bolts using the ST.

    ST 18270KA010 SOCKET

    Fig 2: Inserting Steel Rod Into Exhaust Cam Sprocket RH Hole
    G08562997Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the exhaust cam sprocket RH.
scientia non olet · About LEMON Manuals