Emission Control Systems (Aux. Emission Control Devices) (H4DO): Canister: Removal

Disconnect the ground cable from battery.

Fig 1: Disconnecting Ground Cable From Battery
Courtesy of SUBARU OF AMERICA, INC.
Remove the rear wheel LH.
Lift up the vehicle.
Remove the rear mud guard LH. Refer to REMOVAL .
Disconnect the quick connectors of the vent tube (A), canister drain tube (B) and charge tube (C), and remove the tubes from tube clamp (D).
NOTE: Disconnect the quick connector as shown in the figure.

Fig 2: Disconnecting Quick Connector
Courtesy of SUBARU OF AMERICA, INC.

Fig 3: Identifying Vent Tube, Canister Drain Tube And Charge Tube Quick Connectors And Tube Clamp
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the connector (A) from the canister and remove the canister from the vehicle.

Fig 4: Identifying Canister Connector
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the vent tube (A), canister drain tube (B) and charge tube (C) from the canister.
NOTE: Disconnect the quick connector as shown in the figure.

Fig 5: Disconnecting Quick Connector
Courtesy of SUBARU OF AMERICA, INC.

Fig 6: Identifying Vent Tube, Canister Drain Tube And Charge Tube
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the connector (A) from the leak check valve, and remove the connector assembly from the canister clip.

Fig 7: Identifying Leak Check Valve Connector
Courtesy of SUBARU OF AMERICA, INC.