LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System - Seats >> Front Seat >> Disassembly >> Passenger's Seat

Passenger's Seat

CAUTION:
  • If the seat cushion cover is removed or replaced, make sure to perform occupant detection system adjustment after installing the seat. < Ref. to OPERATION , System Calibration (Rezeroing). >

    Failure to do so may prevent the passenger's airbag from operating properly.

  • The occupant detection system (passenger seat only) control module, occupant detection sensor, seat cushion pad and seat cushion frame are considered as a single seat cushion pad and frame assembly. Never remove the occupant detection control module or the occupant detection sensor from the seat cushion frame.
  • If the seat cushion cover is removed, make sure to replace the hang wire on the seat cushion side with a new wire.
  1. Remove the seat from vehicle. < Ref. to REMOVAL , Front Seat. >
    NOTE: For power seat, lift the seating face before removing the seat.
  2. Refer to the disassembly procedures for the driver's seat.
scientia non olet · About LEMON Manuals