LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> SUBARU Eyesight System (Driver Assist) (Diagnostics) >> Camera Adjustment, Inspection >> Procedure >> Shim Adjustment

Shim Adjustment

  1. Turn the ignition switch to OFF.
  2. Detach the stereo camera cover, and remove the stereo camera. < Refer to REMOVAL , Stereo Camera. >
  3. Remove the stereo camera spacer, and insert the shim into the body and camera spacer.
    NOTE:
    • Inserting the shim (031105000) into the vehicle front side makes camera downward.
    • Inserting the shim (031105000) into the vehicle rear side makes camera upward.
    • There is a case that the shim may be inserted at the production line, but it is not abnormal.
  4. Install the stereo camera spacer.

    Tightening torque: 

    5.5±1.0 N.m (0.56±0.10 kgf-m, 4.1±0.7 ft-lb) 

  5. Install the stereo camera. < Refer to REMOVAL , Stereo Camera. >
  6. Perform the camera all adjustment mode (replacement/removal). < Refer to CAMERA ALL ADJUSTMENT MODE (REPLACEMENT/REMOVAL) , PROCEDURE, Camera Adjustment, Inspection. >
scientia non olet · About LEMON Manuals