Adjustment Value Clear

Perform when replacing stereo camera. (Do not perform when performing stereo camera re-adjustment and inspection)

1. On «Camera adjustment, inspection» display, select {Camera individual adjustment mode}.
2. On «Camera individual adjustment mode» display, select {Clear adjustment value}.
3. When «Perform camera adjustment/inspection. Press OK when the preparations have been made.» is displayed, if preparation is ready, select {OK}.
4. When «Clear the adjustment value.» is displayed, select {OK}.
5. When «Clearing adjustment value...» is displayed, wait until process finishes.
6. When the adjustment value clear is finished correctly, and «Adjustment value cleared OK!» is displayed, select {OK} to finish.
7. Turn the ignition switch to OFF and wait for approx. 5 seconds or more.
   CAUTION: If the ignition switch OFF period is short, the adjustment value clear can not be performed correctly.
8. Next, perform the camera all adjustment mode (replacement/removal). < Refer to CAMERA ALL ADJUSTMENT MODE (REPLACEMENT/REMOVAL) , PROCEDURE, Camera Adjustment, Inspection. >