LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Forester XT Touring >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Cooling System (H4DO)) >> Water Pump >> Removal >> Water Pump Pulley

Water Pump Pulley

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground cable from battery.
    Fig 1: Connecting/Disconnecting Battery Ground Terminal
    G08570271Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the V-belts. < Refer to REMOVAL , V-belt. >
  3. Remove the main fan motor assembly. < Refer to REMOVAL , Radiator Main Fan and Fan Motor. >
  4. Lift up the vehicle.
  5. Remove the under cover. < Refer to REMOVAL , Front Under Cover. >
  6. Remove the water pump pulley using the ST.

    ST1 18355AA000 PULLEY WRENCH

    ST2 18334AA030 PULLEY WRENCH PIN SET

    Fig 2: Removing Water Pump Pulley Using ST
    G08563291Courtesy of SUBARU OF AMERICA, INC.