LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Forester XT Touring >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation System & Driver Information Center >> Combination Meter System >> Inspection >> Check ECO Gauge (Model With Luminescent Meter)

Check ECO Gauge (Model With Luminescent Meter)

Step Check Yes No
1 CHECK DIAGNOSTIC TROUBLE CODE (DTC). 
  1. Prepare the Subaru Select Monitor kit.
  2. Turn the ignition switch to ON (engine OFF) and run the "PC application for Subaru Select Monitor".
  3. On «System Selection Menu» display, select {Integ. unit mode}.
  4. Select the {Diagnostic Code(s) Display}.
 Is a DTC of high-speed CAN detected? Perform the diagnosis according to DTC.< Refer to LIST , List of Diagnostic Trouble Code (DTC). > Go to step 2  .
2 CHECK ECO GAUGE. 
Perform the self-diagnosis of combination meter.< Refer to SELF-DIAGNOSIS , INSPECTION, Combination Meter System. >		 Does ECO gauge operate properly? Check the connection status of the harness and connector that may have a temporary poor contact. Replace the meter case assembly.
scientia non olet · About LEMON Manuals