Work On The Engine Unit Only

WARNING: This page is about a different variant/trim than selected.

Remove the crank pulley. Refer to , REMOVAL , Crank Pulley.
Remove the blow-by pipe from the intake manifold protector RH.

Fig 1: Identifying Vacuum Hose (B), Vacuum Hose (C), Vacuum Hose (D), Vacuum Hose (E) And Clip (A)
Courtesy of SUBARU OF AMERICA, INC.
Remove vacuum hose (B), vacuum hose (C), vacuum hose (D) and vacuum hose (E) from the clip (A).

Fig 2: Locating Engine Harness Clip
Courtesy of SUBARU OF AMERICA, INC.
Remove the clip which holds the engine harness to the hose clip stay assembly.

Fig 3: Identifying Front Timing Belt Cover
Courtesy of SUBARU OF AMERICA, INC.
Remove timing belt cover RH (B) together with the hose clip stay assembly (A).
Remove timing belt cover (LH) (D) together with the oxygen (A/F) sensor bracket (C).
Remove front timing belt cover (E).

Fig 4: Identifying Vacuum Hoses
Courtesy of SUBARU OF AMERICA, INC.