Air By-pass Valve: Removal

WARNING: This page is about a different variant/trim than selected.

Remove the collector cover.
Disconnect the vacuum control hose from the PCV pipe, and remove the vacuum control hose from the clip (A).

Fig 1: Locating Vacuum Control Hose Clip
Courtesy of SUBARU OF AMERICA, INC.
Loosen the clamp which holds the air by-pass valve to the intake duct.

Fig 2: Locating Air By-Pass Valve And Clamp
Courtesy of SUBARU OF AMERICA, INC.
Lift up the vehicle.
Remove the under cover. Ref. to REMOVAL , Front Under Cover.
Remove the air by-pass valve from the intake duct.

Fig 3: Locating Air By-Pass Valve
Courtesy of SUBARU OF AMERICA, INC.