Method With Angle Gauge

WARNING: This page is about a different variant/trim than selected.

Clean the crankshaft thread using compressed air.
Install the crank pulley.
Apply engine oil to the crank pulley bolt seat and thread.
Tighten the crank pulley bolts.
1. Remove the radiator main fan motor assembly and radiator sub motor assembly. Ref. to REMOVAL , Radiator Main Fan and Fan Motor. Ref. to REMOVAL , Radiator Sub Fan and Fan Motor.
2. Use the ST1 to lock the crank pulley, and temporarily tighten the crank pulley bolt.
  ST1 499977100 CRANK PULLEY WRENCH
  
  Tightening torque:
  
  47 N.m (4.8 kgf-m, 34.7 ft-lb)
  
  Fig 1: Identifying Timing Marks
  Courtesy of SUBARU OF AMERICA, INC.
3. Set the ST2, use the ST1 to lock the crank pulley, and tighten the crank pulley bolt to the specified angle.
  ST1 499977100 CRANK PULLEY WRENCH
  
  ST2 18854AA000 ANGLE GAUGE
  
  NOTE: Attach the magnet used for securing the ST2 (ANGLE GAUGE) to ST1.
  
  Tightening angle:
  
  60°±5°
  
  Fig 2: Attaching Magnet To ST1
  Courtesy of SUBARU OF AMERICA, INC.
4. Install the radiator main fan motor assembly and radiator sub motor assembly. Ref. to INSTALLATION , Radiator Main Fan and Fan Motor. Ref. to INSTALLATION , Radiator Sub Fan and Fan Motor.
Install the V-belts. Ref. to INSTALLATION , V-belt.