LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Legacy Premium, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transmission) >> Transmission Mounting System >> Removal >> Transmission Rear CROSSMEMBER & Rear Cushion Rubber

Transmission Rear CROSSMEMBER & Rear Cushion Rubber

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground cable from battery.
  2. Lift up the vehicle.
  3. Remove the under cover. Ref. to REMOVAL , Front Under Cover.
  4. Remove the front exhaust pipe. Ref. to REMOVAL , Front Exhaust Pipe.
  5. Remove the heat shield cover.
    Fig 1: Identifying Heat Shield Cover
    G05019661Courtesy of SUBARU OF AMERICA, INC.
  6. Set the transmission jack under transmission. Make sure that the support plate of transmission jack does not touch the oil pan.
  7. Remove the transmission rear crossmember.
    Fig 2: Locating Transmission Rear Crossmember
    G06651991Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the rear cushion rubber.
scientia non olet · About LEMON Manuals