LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Legacy Premium, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transmission) >> Drive Pinion Shaft Assembly >> Removal

Drive Pinion Shaft Assembly: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission assembly from the vehicle. Ref. to REMOVAL , Automatic Transmission Assembly.
  2. Pull out the torque converter assembly. Ref. to REMOVAL , Torque Converter Assembly.
  3. Remove the transmission harness connector from stay.
  4. Remove the ATF inlet and outlet pipes. Ref. to REMOVAL , ATF Cooler Pipe and Hose.
  5. Separate the converter case and transmission case. Ref. to REMOVAL , Converter Case.
  6. Remove the drive pinion shaft mounting bolts, and then remove the drive pinion shaft assembly from oil pump cover.
    Fig 1: Identifying Drive Pinion Shaft Mounting Bolts
    G05022351Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the oil pump cover from AT main case. Ref. to OIL PUMP COVER .
scientia non olet · About LEMON Manuals