LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Legacy Premium, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transmission) >> Converter Case >> Removal

Converter Case: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission assembly from the vehicle. Ref. to REMOVAL , Automatic Transmission Assembly.
  2. Remove the torque converter assembly. Ref. to REMOVAL , Torque Converter Assembly.
  3. Remove the transmission harness connector from stay.
  4. Remove the turbine speed sensor 1. Ref. to REMOVAL , Turbine Speed Sensor 1.
  5. Remove the ATF inlet and outlet pipes. Ref. to REMOVAL , ATF Cooler Pipe and Hose.
  6. Remove the converter case attachment bolts.
  7. Lay along the transmission body, and then remove the oil pan.
  8. Remove the three converter case mounting bolts (TORX®).

    ST 18676AA020 TORX® WRENCH

    Fig 1: Removing Converter Case Mounting Bolts
    G05668863Courtesy of SUBARU OF AMERICA, INC.
  9. Separate the converter case by lightly tapping with plastic hammer.
  10. Remove the front differential assembly. Ref. to REMOVAL , Front Differential Assembly.
  11. Remove the oil seal from converter case.
scientia non olet · About LEMON Manuals