Water Pump: Installation

WARNING: This page is about a different variant/trim than selected.

Install the water pump onto cylinder block LH.
NOTE:
- Use a new gasket.
- Use new water pump sealing.
- When installing the water pump, tighten bolts in two stages in alphabetical order as shown in the figure.
Tightening torque:

First: 12 N.m (1.2 kgf-m, 8.9 ft-lb)

Second: 12 N.m (1.2 kgf-m, 8.9 ft-lb)

Fig 1: Locating Water Pump Bolts
Courtesy of SUBARU OF AMERICA, INC.
Install the hose to water pump.
Install the tensioner bracket.
Tightening torque: 24.5 N.m (2.5 kgf-m, 18.1 ft-lb)

Fig 2: Identifying Tensioner Bracket
Courtesy of SUBARU OF AMERICA, INC.
Install the belt cover No. 2 LH.
Tightening torque: 5 N.m (0.5 kgf-m, 3.7 ft-lb)

Fig 3: Locating Belt Cover No. 2
Courtesy of SUBARU OF AMERICA, INC.
Install the cam sprocket LH. Ref. to INSTALLATION , Cam Sprocket.
Install the belt idler No. 2 (C).
Tightening torque: 39 N.m (4.0 kgf-m, 28.8 ft-lb)
Install the belt idler (B).
Tightening torque: 25 N.m (2.5 kgf-m, 18.4 ft-lb)
Install the automatic belt tension adjuster (A) with the tension rod held by a pin. Ref. to AUTOMATIC BELT TENSION ADJUSTER ASSEMBLY AND BELT IDLER , INSTALLATION, Timing Belt.

Fig 4: Removing Belt Idler
Courtesy of SUBARU OF AMERICA, INC.
Install the timing belt. Ref. to TIMING BELT , INSTALLATION, Timing Belt.
Install the timing belt cover. Ref. to INSTALLATION , Timing Belt Cover.
Install the crank pulley. Ref. to INSTALLATION , Crank Pulley.
Install the V-belts. Ref. to INSTALLATION , V-belt.
Install the radiator. Ref. to INSTALLATION , Radiator.
Install the collector cover.