Brake Pedal: Installation

Install the bolt and nut which secure the brake pedal bucket.
Tightening torque:

18 N.m (1.8 kgf-m, 13.0 ft-lb)
Install clevis pin and snap pin which secure the operating rod to the brake pedal.
NOTE:
- Replace with a new clevis pin.
- Apply a thin coat of KOPR-KOTE (Part No. 003603001) to the clevis pin.
Fig 1: Identifying Clevis Pin, Pedal, Snap Pin And Operating Rod
Courtesy of SUBARU OF AMERICA, INC.
Connect the stop light switch connector.
Check that the brake light operate properly.
Check the brake pedal after installation. Refer to INSPECTION , Brake Pedal .