Brake Pedal: Inspection

1. Move the brake pedal pads in a horizontal direction with a force of approx. 10 N (1 kgf, 2 lbf), and check that the pedal deflection is in the range of specifications.
   CAUTION: If excessive deflection is noted, replace with a new bushing.

   Deflection of brake pedal: 

   Service limit 

   5.0 mm (0.197 in) or less 

   Fig 1: Checking Deflection Of Brake Pedal

   Courtesy of SUBARU OF AMERICA, INC.
2. Check the position of the pedal pad.

   Pedal height L: 

   150 - 160 mm (5.91 - 6.29 in) 

   Brake pedal free play A: 

   0.5 - 2 mm (0.020 - 0.079 in) [When pulling the brake pedal upward with a force of less than 10 N(1 kgf, 2 lbf).] 

   Fig 2: Identifying Stop Light Switch, Mat, Toe Band And Brake Booster Operating Rod

   Courtesy of SUBARU OF AMERICA, INC.
3. If it is not within the specification, loosen the lock nut of brake booster operating rod, and rotate the rod to adjust the pedal height L within the specification.
4. Tighten the lock nut.

Tightening torque: 

22 N.m (2.2 kgf-m, 16.2 ft-lb)