Glove Box: Removal

Disconnect the ground cable from the battery.
Remove the console box. < Ref. to REMOVAL , Console Box. >
Remove the console front panel.

Fig 1: Identifying Glove Box Hook
Courtesy of SUBARU OF AMERICA, INC.

NOTE: For the AT model, remove the ring indicator.
For the MT model, remove the shift knob.
Remove the console side garnish.

Fig 2: Identifying Console Side Garnish
Courtesy of SUBARU OF AMERICA, INC.
Remove the front inside scuff plate (A) and front pillar lower trim (B). < Ref. to REMOVAL , Lower Inner Trim. >

Fig 3: Identifying Scuff Plate And Front Pillar Lower Trim
Courtesy of SUBARU OF AMERICA, INC.
Remove the clips, and remove the glove box lower cover.

Fig 4: Identifying Glove Box Lower Cover And Clips
Courtesy of SUBARU OF AMERICA, INC.
Remove the console side panel.

Fig 5: Locating Console Side Panel
Courtesy of SUBARU OF AMERICA, INC.
Remove the instrument panel side cover, and remove the clip.

Fig 6: Identifying Instrument Panel Side Cover And Clip
Courtesy of SUBARU OF AMERICA, INC.
Remove the strap of the glove box damper.
Remove the backside of stopper on one side, and remove the glove box lid.

Fig 7: Locating Glove Box Lid
Courtesy of SUBARU OF AMERICA, INC.
Remove the harness holder and connector holder.

Fig 8: Removing Harness Holder And Connector Holder
Courtesy of SUBARU OF AMERICA, INC.
Remove the screws and upper clip to remove the glove box.

Fig 9: Locating Glove Box And Screws
Courtesy of SUBARU OF AMERICA, INC.