LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Fuel Injection (Fuel Systems) (H4SO)) >> 12.Fuel Injector >> A: Removal >> 1. RH Side

1. RH Side

WARNING: This page is about a different variant/trim than selected.
  1. Release the fuel pressure.

    < Ref. to RELEASING OF FUEL PRESSURE , PROCEDURE, Fuel. >

  2. Disconnect the ground cable from the battery.
    Fig 1: Identifying Ground Cable From Battery
    G05019586
  3. Open the fuel filler flap lid, and remove the fuel filler cap.
  4. Remove the air intake duct and air cleaner case.

    < Ref. to REMOVAL , Air Intake Duct. > < Ref. to REMOVAL , Air Cleaner Case. >

  5. Remove the spark plug cords from spark plugs (#1 and #3 cylinders).
  6. Remove the fuel pipe protector RH.
    Fig 2: Locating Fuel Pipe Protector RH
    G04997361
  7. Disconnect the connectors (A) from fuel injector.
  8. Remove the harness band (B) which holds the engine harness to injector pipe.
    Fig 3: Locating Harness Band
    G04997406
  9. Remove the bolt which holds fuel injector pipe onto intake manifold.
    Fig 4: Locating Fuel Injector Pipe Bolts - RH Side
    G04997365
  10. Remove the fuel injector while lifting up the fuel injector pipe.
scientia non olet · About LEMON Manuals