Air Cleaner Case: Removal

WARNING: This page is about a different variant/trim than selected.

Disconnect the ground cable from the battery.

Fig 1: Disconnecting Ground Cable From Battery
Remove the air intake duct. < Ref. to REMOVAL , Air Intake Duct. >
Disconnect the connector from mass air flow and intake air temperature sensor.

Fig 2: Locating Connector From Mass Air Flow And Intake Air Temperature Sensor
Loosen clamps (A) which connect the air cleaner case and the intake duct.
Remove the clip (B) securing the upper side of air cleaner case.

Fig 3: Identifying Clamps And Clip
Remove the air cleaner case (rear) and air cleaner element.

Fig 4: Removing Air Cleaner Case And Air Cleaner Element
Remove the bolts (A) and nut (B) which secure the air cleaner case to body.

Fig 5: Identifying Air Cleaner Case Body
Remove the air cleaner case (front).