Transmission Rear CROSSMEMBER And Rear Cushion Rubber
WARNING: This page is about a different variant/trim than selected.
- Install the rear cushion rubber.
Tightening torque:
40 N.m (4.1 kgf-m, 29.5 ft-lb)
- Install the cross.
Tightening torque:
T1: 35 N.m (3.6 kgf-m, 26 ft-lb)
T2: 75 N.m (7.6 kgf-m, 55 ft-lb)
- Remove the transmission jack.
- Install the heat shield cover.
- Install the front, center and rear exhaust pipes, and the muffler.
< Ref. to INSTALLATION , Front Exhaust Pipe. > < Ref. to INSTALLATION , Rear Exhaust Pipe. > < Ref. to INSTALLATION , Muffler. >