Rear Exhaust Pipe: Installation

WARNING: This page is about a different variant/trim than selected.

Apply a coat of spray type lubricant to the mating area of cushion rubber.
Install the rear exhaust pipe bracket to cushion rubber.

Fig 1: Locating Cushion Rubber
Install the rear exhaust pipe to muffler.
NOTE: Use a new gasket and self-locking nut.

Tightening torque: 48 N.m (4.9 kgf-m, 35.4 ft-lb)
- LH side
  
  Fig 2: Locating Rear Exhaust Pipe Nuts - LH Side
- RH side
  
  Fig 3: Locating Rear Exhaust Pipe Nuts - RH Side
Install the rear exhaust pipe to center exhaust pipe.
Tightening torque: 18 N.m (1.8 kgf-m, 13.0 ft-lb)

Fig 4: Identifying Rear Exhaust Pipe