LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical (H4SO)) >> Oil Switching Solenoid Valve >> Removal >> LH Side

LH Side

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground cable from the battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G04988132Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the V-belts.

    < Ref. to REMOVAL , V-belt. >

  3. Remove the crank pulley.

    < Ref. to REMOVAL , Crank Pulley. >

  4. Remove the timing belt cover.

    < Ref. to REMOVAL , Timing Belt Cover. >

  5. Remove the timing belt.

    < Ref. to REMOVAL , Timing Belt. >

  6. Remove the cam sprocket.

    < Ref. to REMOVAL , Cam Sprocket. >

  7. Remove the timing belt cover No. 2 (LH).
  8. Disconnect the connector from the oil switching solenoid valve.
  9. Remove the oil switching solenoid valve.
  10. Remove the variable valve lift diagnosis oil pressure switch.

    < Ref. to REMOVAL , Variable Valve Lift Diagnosis Oil Pressure Switch. >

  11. Remove the oil switching solenoid valve holder from the cylinder head.
    Fig 2: Identifying Oil Switching Solenoid Valve Holder And Cylinder Head
    G05017215Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals