Cam Sprocket: Installation

WARNING: This page is about a different variant/trim than selected.

Install the cam sprocket No. 1 and No. 2. To lock the camshaft, use the ST.
ST 18231AA010 CAM SPROCKET WRENCH

NOTE: CAM SPROCKET WRENCH (499207100) can also be used.

Tightening torque:

78 N.m (8.0 kgf-m, 57.9 ft-lb)

NOTE: Do not confuse left and right side cam sprockets during installation. Cam sprocket No. 2 is identified by the protrusion used by the camshaft position sensor monitor.

Fig 1: Tightening Cam Sprocket No. 2 Using Cam Sprocket Wrench ST (499207100)
Courtesy of SUBARU OF AMERICA, INC.
Install the camshaft position sensor. < Ref. to INSTALLATION , Camshaft Position Sensor. >
Install the timing belt. < Ref. to INSTALLATION , Timing Belt. >
Install the timing belt cover.
< Ref. to INSTALLATION , Timing Belt Cover. >
Install the crank pulley. < Ref. to INSTALLATION , Crank Pulley. >
Install the V-belts. < Ref. to INSTALLATION , V-belt. >