LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Timing Belt >> Engine Mechanical (H4DOTC) >> Cylinder Head >> Removal

Cylinder Head: Removal

  1. Remove the V-belts. < Ref. to REMOVAL , V-belt. >
  2. Remove the crank pulley.

    < Ref. to REMOVAL , Crank Pulley. >

  3. Remove the timing belt cover.

    < Ref. to REMOVAL , Timing Belt Cover. >

  4. Remove the timing belt.

    < Ref. to REMOVAL , Timing Belt. >

  5. Remove the cam sprocket.

    < Ref. to REMOVAL , Cam Sprocket. >

  6. Remove the intake manifold.

    < Ref. to REMOVAL , Intake Manifold. >

  7. Remove the bolt which installs the A/C compressor bracket on cylinder head.
  8. Remove the camshaft. < Ref. to REMOVAL , Camshaft. >
  9. Remove the cylinder head bolts in alphabetical sequence shown in the figure.

    Leave the bolts (A) and (D) engaged by three or four threads to prevent the cylinder head from falling.

    Fig 1: Identifying Cylinder Head Bolts Loosening Sequence
    G04998729
  10. While tapping the cylinder head with a plastic hammer, separate it from cylinder block.

    Remove the bolts (A) and (D) to remove cylinder head.

    Fig 2: Identifying Cylinder Head Bolts Loosening Sequence
    G04998729
  11. Remove the cylinder head gasket.
    CAUTION: Be careful not to scratch the mating surface of cylinder head and cylinder block.
  12. Similarly, remove the cylinder head (RH).
scientia non olet · About LEMON Manuals