LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior/Interior Trim >> Upper Inner Trim >> Removal

Upper Inner Trim: Removal

  1. From the top side of the trim, remove the metal clip using a flat tip screwdriver.
    Fig 1: Removing Metal Clip Using Flat Tip Screwdriver
    G05023006
    CAUTION: When the metal clip comes off or becomes damaged, replace both trim and metal clips with new parts.
  2. Remove the front pillar upper trim.
    Fig 2: Identifying Clip
    G05023007
  3. Remove the front inside scuff plate, rear inside scuff plate and center pillar lower trim. < Ref. to REMOVAL , Lower Inner Trim. >
  4. Remove the cap on the upper side of the pillar trim, and remove the bolt inside.
    Fig 3: Identifying Trim Bolt
    G05023008
  5. Remove the center pillar upper trim.
    Fig 4: Locating Bolts
    G05023009
  6. Remove the seat belt lower anchor bolt at the center pillar lower port. (Driver's seat)
  7. Refer to the removal procedure of "FRONT SEAT BELT " for the passenger's seat. < Ref. to , OUTER SEAT BELT ASSEMBLY , REMOVAL, FRONT SEAT BELT. >
scientia non olet · About LEMON Manuals