Outer Seat Belt Assembly

Fold the backrest all the way forward, and then move the front seat all the way forward.
Turn the ignition switch to OFF, disconnect the battery ground cable, and wait more than 20 seconds.
Remove the center pillar lower trim. < Ref. to REMOVAL , Lower Inner Trim. >
Remove the center pillar upper trim. < Ref. to REMOVAL , Upper Inner Trim. >
Remove the bolt, then remove the center pillar inner protector lower.
Remove the bolt, and then remove the shoulder anchor.

Fig 1: Identifying Shoulder Anchor Bolt
Remove the bolt, and then remove the adjustable anchor assembly.

Fig 2: Identifying Adjustable Anchor Assembly Bolt
Disconnect the pretensioner connector (A), remove the bolt, and remove the seat belt retractor.

Fig 3: Identifying Pretensioner Connector And Tension Reducer Connector

NOTE: Disconnect the tension reducer connector (B) for the seat belt retractor with a tension reducer function.
On the passenger's side, disconnect the connector of the belt tension sensor.

Fig 4: Locating Tension Reducer Connector
CAUTION:
- Do not drop or subject the pretensioner to any impact.
- Since the pretensioner and bracket are integrated as a unit, do not disassemble them.