Camshaft Sprocket: Installation
WARNING: This page is about a different variant/trim than selected.
- Install camshaft sprocket No. 1 and No. 2. To lock camshaft, use ST.
ST 18231AA010 CAMSHAFT SPROCKET WRENCH
NOTE: CAMSHAFT SPROCKET WRENCH (499207100) is also can be used.Tightening torque:
78 N.m (8.0 kgf-m, 57.9 ft-lb)
CAUTION: Do not confuse left and right side camshaft sprockets during installation. The camshaft sprocket No. 2 is identified by a projection used to monitor camshaft position sensor. - Install camshaft position sensor.
< Ref. to INSTALLATION , CAMSHAFT POSITION SENSOR. >
- Install timing belt. < Ref. to INSTALLATION , Timing Belt. >
- Install timing belt cover. < Ref. to INSTALLATION , TIMING BELT COVER. >
- Install crankshaft pulley. < Ref. to INSTALLATION , CRANKSHAFT PULLEY. >
- Install V-belt. < Ref. to INSTALLATION , V-BELT. >