Back-Up Light And Neutral Position Switch

WARNING: This page is about a different variant/trim than selected.

Disconnect ground cable from battery.
Remove the air intake duct and cleaner case or the air intake chamber. (Non-TURBO model) < Ref. to REMOVAL , AIR CLEANER CASE > and < Ref. to REMOVAL , AIR INTAKE DUCT. >
Remove the intercooler. (Turbo model) < Ref. to REMOVAL , INTERCOOLER. >
Disconnect the connector of back-up light switch and neutral position switch.
- NON-TURBO MODEL
  
  Fig 1: Identifying Back-Up Light Switch And Neutral Position Switch (Non-Turbo Model)
  Courtesy of SUBARU OF AMERICA, INC.
- TURBO MODEL
  
  Fig 2: Identifying Back-Up Light Switch And Neutral Position Switch (Turbo Model)
  Courtesy of SUBARU OF AMERICA, INC.
Lift-up the vehicle.
Remove the back-up light switch and neutral position switch with harness.

Fig 3: Identifying Back-Up Light Switch And Neutral Position Switch
Courtesy of SUBARU OF AMERICA, INC.