LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Baja Turbo, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Manual Transmission And Differential) >> Reverse Idler Gear >> Removal

Reverse Idler Gear: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the manual transmission assembly from vehicle. < Ref. to REMOVAL , MANUAL TRANSMISSION ASSEMBLY. >
  2. Remove the back-up light switch and neutral position switch. < Ref. to REMOVAL , SWITCHES AND HARNESS. >
  3. Remove the transfer case with extension case assembly. < Ref. to REMOVAL , TRANSFER CASE AND EXTENSION CASE ASSEMBLY. >
  4. Remove the transmission case. < Ref. to REMOVAL , DRIVE PINION SHAFT ASSEMBLY. >
  5. Remove the drive pinion shaft assembly. < Ref. to REMOVAL , DRIVE PINION SHAFT ASSEMBLY. >
  6. Remove the main shaft assembly.

    < Ref. to REMOVAL , MAIN SHAFT ASSEMBLY. >

  7. Remove the differential assembly. < Ref. to REMOVAL , FRONT DIFFERENTIAL ASSEMBLY. >
  8. Remove the shifter forks and rods. < Ref. to REMOVAL , SHIFTER FORK AND ROD. >
  9. Pull out the straight pin, and remove the idler gear shaft, reverse idler gear and washer.
    Fig 1: Identifying Straight Pin, Idler Gear Shaft, Idler Gear And Washer
    G04991030Courtesy of SUBARU OF AMERICA, INC.
  10. Remove the reverse shifter lever.
scientia non olet · About LEMON Manuals