Master Cylinder: Installation

WARNING: This page is about a different variant/trim than selected.

Install the master cylinder to body, and install the clutch pipe to master cylinder.
NOTE: Check that the pipe is routed properly.

Tightening torque:

T1: 15 N.m (1.5 kgf-m, 10.8 ft-lb)

T2: 18 N.m (1.8 kgf-m, 13.0 ft-lb)

Fig 1: Identifying Master Cylinder And Clutch Pipe
Courtesy of SUBARU OF AMERICA, INC.
Apply a coat of grease to the clevis pin.
Connect the push rod of master cylinder to clutch pedal, and install the new clevis pin and snap pin.

Fig 2: Identifying Snap Pin, Clevis Pin And Push Rod
Courtesy of SUBARU OF AMERICA, INC.
After bleeding air from the system, ensure that clutch operates properly.
Adjust the clutch pedal. < Ref. to ADJUSTMENT , CLUTCH PEDAL. >
Install the air cleaner case and air intake duct. < Ref. to INSTALLATION , AIR CLEANER CASE (H4SO) > and < Ref. to INSTALLATION , AIR INTAKE DUCT (H4SO). >
Install the intercooler. (TURBO model) < Ref. to INSTALLATION , INTERCOOLER (H4DOTC). >