Clutch Pedal: Adjustment

WARNING: This page is about a different variant/trim than selected.

Measure the full stroke amount of clutch pedal.
NOTE:
- Measure the length between seat cushion front end and center portion of clutch pedal.
- Slide the seat at seventh notch from first notch.
Specified clutch pedal full stroke: A 130 - 135 mm (5.12 - 5.31 in)

Fig 1: Identifying Clutch Pedal Full Stroke
Courtesy of SUBARU OF AMERICA, INC.
If not as specified, loosen the clutch stopper nut to adjust it.
Tightening torque (Clutch stopper nut): 8 N.m (0.8 kgf-m, 5.8 ft-lb)
Loosen the push rod lock nut.

Fig 2: Identifying Clevis Pin, Snap Ring, Push Rod And Push Rod Lock Nut
Courtesy of SUBARU OF AMERICA, INC.
Turn the push rod to adjust.
1. Ensure that the clutch pedal contacts stopper bolt, when releasing the clutch pedal.
2. Ensure that the clutch pedal contacts clutch pedal bracket stopper, when fully depressing the clutch pedal.
  
  Fig 3: Turning Push Rod To Adjust
  Courtesy of SUBARU OF AMERICA, INC.
Turn the push rod clockwise to shorten until clearance is made at clutch switch.

Fig 4: Identifying Clutch Switch And Stopper
Courtesy of SUBARU OF AMERICA, INC.
Turn the push rod counter clockwise to lengthen until clutch pedal contacts to clutch switch.
Turn the push rod further 270° counterclockwise to lengthen (arrow direction as shown in Fig 5).

Fig 5: Turning Push Rod Counterclockwise To Lengthen
Courtesy of SUBARU OF AMERICA, INC.
Move the clevis pin in lateral direction to ensure it moves smoothly.
Tighten the push rod lock nut.
Tightening torque: 10 N.m (1.0 kgf-m, 7.2 ft-lb)
Measure the full stroke amount of clutch pedal again.
Specified clutch pedal full stroke: A 130 - 135 mm (5.12 - 5.31 in)
Install the clutch start switch. < Ref. to INSTALLATION , CLUTCH SWITCH. >