Clutch Switch (With Cruise Control)

WARNING: This page is about a different variant/trim than selected.

Install the clutch switch and clutch pedal stopper so that the gap between them is 0 mm (0 in).
Tightening torque: 8 N.m (0.8 kgf-m, 5.8 ft-lb)

Fig 1: Identifying Clutch Switch And Stopper
Courtesy of SUBARU OF AMERICA, INC.
Measure stroke of clutch pedal.
Specified clutch pedal full stroke: A 130 - 135 mm (5.12 - 5.31 in)

Fig 2: Identifying Clutch Pedal Full Stroke
Courtesy of SUBARU OF AMERICA, INC.
If the clutch pedal stroke is out of specification, adjust the stroke. < Ref. to ADJUSTMENT , CLUTCH PEDAL. >
Connect clutch switch connector.