LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Baja Turbo, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Clutch System) >> Clutch Pedal >> Removal

Clutch Pedal: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the steering column. < Ref. to REMOVAL , Tilt Steering Column . >
  2. Disconnect the connectors from stop light and clutch switches.
  3. Remove the snap pins which secure lever to push rod and operating rod.
  4. Remove the clevis pins which secure lever to push rod and operating rod.
    Fig 1: Identifying Operating Rod, Push Rod, Snap Ring And Clevis Pin
    G04991092Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the accelerator pedal.

    < Ref. to REMOVAL , ACCELERATOR PEDAL (H4SO). >

  6. Remove the air cleaner case and intake duct. < Ref. to REMOVAL , AIR CLEANER CASE (H4SO) > and < Ref. to REMOVAL , AIR INTAKE DUCT (H4SO). >
  7. Remove the intercooler. (TURBO model) < Ref. to REMOVAL , INTERCOOLER (H4DOTC). >
  8. Remove the nut which secures clutch master cylinder.
    Fig 2: Identifying Clutch Master Cylinder
    G05003694Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the bolts and nuts which secure brake and clutch pedals, and remove the pedal assembly.
scientia non olet · About LEMON Manuals