Reverse Check Sleeve: Installation

WARNING: This page is about a different variant/trim than selected.

Install the reverse check sleeve.
Tightening torque:

6.4 N.m (0.65 kgf-m, 4.7 ft-lb)

Fig 1: Installing Reverse Check Sleeve
Courtesy of SUBARU OF AMERICA, INC.
Install the ball, spring, washer and plug to transfer case.
Tightening torque:

9.75 N.m (1.0 kgf-m, 7.2 ft-lb)

Fig 2: Installing Ball, Spring, Washer And Plug
Courtesy of SUBARU OF AMERICA, INC.
Install the shifter arm to transfer case assembly.
Install the transfer case with extension case assembly. < Ref. to , INSTALLATION , Transfer Case and Extension Case Assembly. >
Install the manual transmission assembly into vehicle. < Ref. to , INSTALLATION , Manual Transmission Assembly. >