LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2005 >> Outback R VDC Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Manual Transmission And Differential (5MT)) >> Main Shaft Assembly for Single-Range >> Installation

Main Shaft Assembly for Single-Range: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the needle bearing and oil seal onto the front of transmission main shaft assembly for single range.
    NOTE:
    • Wrap the clutch splined section with vinyl tape to prevent damage to oil seal.
    • Apply grease (UNILUBE #2 or equivalent) to the sealing lip of oil seal.
    • Use a new oil seal.
  2. Install the transmission case knock pin into needle bearing outer race knock pin hole.
    NOTE: Align the end face of seal with surface (A) when installing oil seal.
    Fig 1: Installing Transmission Case Knock Pin Into Needle Bearing Outer Race Knock Pin Hole
    G03832092Courtesy of SUBARU OF AMERICA, INC.
  3. Install the drive pinion assembly. < Ref. to , INSTALLATION , Drive Pinion Shaft Assembly. >
  4. Install the transmission case. < Ref. to , INSTALLATION , Transmission Case. >
  5. Install the transfer case with extension case assembly. < Ref. to , INSTALLATION , Transfer Case and Extension Case Assembly. >
  6. Install the manual transmission assembly into vehicle. < Ref. to , INSTALLATION , Manual Transmission Assembly. >
scientia non olet · About LEMON Manuals