LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1992 >> Legacy Sport >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 2.2L 4-CYL & 2.2L 4-CYL Turbo - VIN [6] >> Removal & Installation >> Cylinder Head >> Installation

Cylinder Head: Installation

  1. Ensure mating surfaces are clean and dry. Install head gasket. Coat head bolt threads with oil. See Fig 1 . Tighten bolts to specification using proper sequence. See TORQUE SPECIFICATIONS  table.
  2. To install remaining components, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS  table.
CAUTION: After initial start-up, recheck cylinder head bolt torque after running engine at normal operating temperature. Retighten head bolts when engine is dead COLD.
Fig 1: Cylinder Head Bolt Tightening Sequence
G91F01163Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals